Why A Clean Motorcycle Engine Means Improved Performance

Sponsored
by Sponsored

Motorcyclists can be a bit obsessive when it comes to maintenance and keeping their engines properly cared for, and for good reason: compared to the typical automobile engine, motorcycle powerplants rev higher, put out more horsepower per liter, and are lighter weight. With a much higher state of tune, a motorcycle engine lives a more stressful life, and to extract maximum performance, they require proper maintenance and care. For some, regular oil changes fulfill their needs, but for those who wish to extract every iota of performance from their bike, cleanliness is next to Godliness. Enter LIQUI MOLY Motorbike Engine Flush.


This additive helps remove deposits from an engine that regular oil changes will not. As a result, internal components are better able to spin, reciprocate, flow, and simply work better, faster, and with less wear. By removing deposits, bearings can spin easier, oil passages flow more efficiently, piston rings seal better, and valvetrains operate with reduced friction.


As an engine revs higher, friction becomes more of a factor, and any reduction in friction pays dividends in performance. Consider every place in an engine where metal meets metal. Here, a thin film of oil is the only thing preventing the two surfaces from scraping each other into metal filings in an instant. Keeping those surfaces clean of deposits and contaminants allows the oil to do its job, and keeps the oil flowing freely. Less friction, less wear, less heat, all equate to better performance and longer engine life.


Using LIQUI MOLY Motorbike Engine Flush will remove dirt, sludge, carbon etc. from the inside of the engine which will help the new oil to perform as best as possible from the beginning on. Furthermore, it will also remove carbon build up at the piston ring groves which will allow the rings to float freely and restore optimal compression. A very effective way to extend the life of any engine, to optimize the oil consumption and to improve performance.


To use LIQUI MOLY Motorbike Engine Flush, add the required amount to warm motor oil before the oil change. After adding additive, allow the engine to idle for 10 minutes. During the application, pull in and hold the clutch lever multiple times for a few seconds. Then drain the oil and change the filter.

Designed for four-stroke motorcycle engines with dry or wet clutches, and safe to use with catalytic converters, LIQUI MOLY Motorbike Engine Flush is a safe and economical method of keeping high performance bike engines clean and working to their maximum potential. This product does not attack common sealing materials, and can even reduce clutch slippage.


Anyone with even a minimal knowledge of engines knows that regular oil changes will keep them running healthier and longer. But for those who are meticulous about maintenance and desire to extract every ounce of performance out of their machines, LIQUI MOLY Motorbike Engine Flush is a great way of taking your maintenance routine to the next level.


For more information, visit your local LIQUI MOLY dealer, or visit liqui-moly.com.


NOTE: This is sponsored content produced in partnership with LIQUI MOLY

Sponsored
Sponsored

More by Sponsored

Comments
Join the conversation
2 of 14 comments
  • Jim Jim on Sep 20, 2024

    Ran engine flushes in the past. Cleans the engine but ruins the clutch. Only good for bikes with a dry clutch.

  • Steve Steve on Sep 22, 2024

    I used it in my Zero and didn't notice much of a difference.

Next