|
|||||||
![]() |
|
|
Thread Tools |
|
|
#21 |
|
Founding Member
![]() Join Date: Nov 2001
Posts: 306
|
I'm looking at this bike, which reminds me of several other bikes. The front reminds me of a squashed Honda F2, the frame and overall layout says 900ss and/or BMW 1100RS, the tail is Buell XB9R, and the rear is Ducati with the underseat tailpipes.
I think that these fellas need to invest as much in design into this bike as they did with the Furia--because it's UUUuuuugly. That's just my squidly opinion. |
|
|
|
| Sponsored Links | Remove Advertisements |
|
Motorcycle Forum Advertisement |
|
|
|
#22 |
|
Founding Member
![]() Join Date: Nov 2001
Posts: 12
|
Squid.
|
|
|
|
|
|
#23 |
|
Founding Member
![]() Join Date: Jun 2007
Posts: 238
|
Are you sure about the 6 speed? I just finished reading the g-b web site and it was mentioned that the frame for the Supertwin was built around the 5 speed (as at the time Moto Guzzi had refused to supply the 6 speed), so the 6 speed would not fit. I was under the impression that the Furia uses the same frame as the Supertwin.
|
|
|
|
|
|
#24 |
|
Founding Member
![]() Join Date: Nov 2001
Location: Newport Coast, CA
Posts: 1,538
|
According to the specs page on the Ghezzi & Brian website.
__________________
I thought I'd found true happiness in my personal bath body bar.... Then I tried DOVE! with 1/4 moisturizing cream!!! |
|
|
|
|
|
#25 |
|
Founding Member
![]() Join Date: Nov 2001
Posts: 5
|
I've heard or read somewhere (here?) that perimeter brakes do not cause the bike to stand up when applied hard with the bike heeled well over deep into a corner. If that's true, I consider it a big plus, not because I normally leave braking until the apex but I do, due to my bicycle road racing career in a previous life, tend to sometimes want to scrub off a little speed after leaning the bike way over.
On a different note entirely: <blockquote> Rear drive gear box: helical tooth gears, ratio 1.35 (17/23) final drive by shaft with two separate cardan joints and floating crown wheel and pinion box, ratio 4.12 (8/33). </blockquote> I wonder what cardan joints and floating crown wheels and pinion boxes are. Is this good? The 8-tooth gear doesn't sound too robust. How often do these need replacement, I wonder? |
|
|
|
|
|
#26 |
|
Founding Member
![]() Join Date: Jun 2007
Posts: 238
|
$16500 from the distributor, includes shipping.
|
|
|
|
![]() |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
|
|






